Grab the harness and find the leads that are going to connect to our cube lights. That way we can see back in here when we start feeding our wires. Pop the top portion of the dash up and let it lay back just like this. ![]() Pick up the dash cluster and go on the back side where there’s going to be a connector to where you can unplug it. Take a rocker switch and pop it right into the cutout on the dash. Pull the rocker switch panel out and we’ll take our harness run it up through just like this. Now go inside the machine and there are two push pins on the bottom of the rocker switch panel here and here. Grab the harness and locate the portion of the harness that has the rocker switch on it. ![]() Now we have the wiring leads here and we’re just going to leave those out for the time being. Pull out the dummy plug on the pulse bus bar and plug in the new SuperATV pulse plug. Now we’re going to start doing some wiring. We’ve already done all this for the other cube light. Leave the bracket loose enough that we can rotate it around whichever way you want. Once you get it in the channel, take the provided allen wrench and start threading it into the nut. Then grab a magnet or a screwdriver with a magnet then take your nut and slide it right down into the channel here. Slip your bolt through just enough so it stays in the bracket. Grab the hardware here and slip it through the bracket. Next, grab the cube light and the bracket provided in the cube light kit. We’re going to have our Pro-Fit cage mount, the mount provided with the cube light, and the hardware provided with the mount. Now we’re going to start getting our brackets mounted up to our cube lights. That way we can pop it up whenever we install the wiring. Don’t completely remove the dash, just remove that hardware. Once you take the instrument cluster out, there are two push pins located here and here. On the opposite side, there’s one pushpin located in the same exact location. Then remove the two pushpins inside of here. Once you remove those four screws, remove the storage compartment and sit it out out of the way. Then open up the storage compartment and there are four T25 screws. There’s gonna be one located right here directly down underneath of the grab handle. Once we have them all removed from the top portion up here, get inside the machine. Pull the two on top of the dash cluster here. Then remove all the pushpins securing the upper portion of the dash. Today I’m gonna be showing you how to install SuperATV’s LED cubelights as well as the pulse plug for the Polaris Ranger.įirst, remove the hood from the machine and set it aside.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |